
POE61S-4AF Characteristics
INPUT:
The PoE extender can only receive power from an
“Ultra PoE” midspan, “Mega PoE” midspan, or
equivalent.
DC Input Voltage Range
45-57VDC
Ripple and Regulation
100mV maximum
WWW.PHIHONG.COM
Immunity
ESD: EN61000-4-2. Level 3
RS: EN61000-4-3. Level 3
EFT/Burst: EN61000-4-4. Level 2
Surge: EN61000-4-5. Level 2
CS: EN61000-4-6. Level 2
Note: RS and CS tested with POE75U-1UP
EMC
EN55022 Class B
FCC Part 15, Class B
DC Input Current
2.5A at 45VDC at maximum load
2.0A at 57VDC at maximum load
Isolation Test
Input to Field Ground: 2121VDC for 1 minute
Output to Field Ground: 2121VDC for 1 minute
Efficiency
84% (typical) at full load and 48VDC
PoE Standard Compliance
Input
12.5K Internal Signature Resistance
Output
Detects a 25K Signature Resistance
Insulation Resistance
Input and Output to field ground: >10 OHM
500VDC
FEATURE:
Over Voltage/Current, Short Circuit Protection
Outputs equipped with short circuit protection and
overload protection as per 802.3af specification
ENVIRONMENTAL:
Temperature
Indicators
Operation -40 to +60°C
Non-operation -40 to +85°C
Humidity
Ethernet
Green Full Duplex, otherwise Half
Duplex
Green 100M, otherwise 10M
Yellow blinking, Ethernet activity
Operation
5 to 90%
POE
INPUT
On: Input power OK
Cable
Designed to operate up to 100 meters per IEEE
802.3, Cat 5e or Cat 6 rated for outdoor use
OUTPUT
Off: No power or
voltage low
On: POE output OK
Off: No POE output
Weather Proof Enclosure
IP67 Compliant
Warranty
Limited Lifetime
Input and Output Data Connector
RJ45
Input/Output Case Ports
3 ? NPT holes compatible with standard ? NPT
conduit piping or Phihong wire glands
PGLAND750/PGLAND750-2 with fully
waterproof AC and Ethernet cables.
Network Switch
Network Switch must be Environment Rated B as
per paragraph 33.4.1.1 of the IEEE802.3at standard.